Konica Minolta bizhub PRESS C1060 - Manual (Page 6)

6
Specific settings do not register with a JDF print job when Add/Map
to Paper Catalog is selected and when JDF is enabled on the Fiery
Color Server
Specify a different paper type other than Plain or Fine for the Paper Catalog entry for the
settings to apply to the JDF print job.
Error message is not localized after selecting Summary Print and
printing a document
The error message displays in English instead of the system language, when approximately
100 characters or more are entered in the Instructions text field in Job Properties.
Some performance test files are slower than the targeted pages per
minute (PPM) rate
In print processing speed tests, the speed might be affected by RIP data compression and
produce different test results. Depending on the print data, print process speeds may increase
from changing the following settings.
• Image Quality = Best to Normal
• Composite Overprint = ON to Off
Cover image of 1-up perfect is incorrect, when Front & Back Together
is selected
When Front & Back Together is selected, and when the sheet size is larger than the cover
image size, the cover image position for 1-up Perfect does not match with the finished sheet
size. Match the cover sheets size with the image size. For example, when body sheet size is
8.5x11 and spine width is one inch, use 18 inch x 11 inch sheets for a cover.
Output Tray menu displays blank field after changing finisher type
When a finisher is connected to the printer and if you change the finisher type, the Output
Tray menu in Configure may display an empty field after changing the finisher type. Connect
the finisher to the printer again, or change the finisher type so that the Output Tray menu
displays “Unassigned”.
Printer driver Change of measuring units for 1-up Perfect booklet type
In Driver > Print setting > Layout > Booklet, if you specify 1-up Perfect as the booklet type,
the measuring unit changes from inches to millimeters. When you confirm the measuring
unit in Launch Wizard, the base unit of the operating system also changes from inches to
millimeters.