Konica Minolta PS5000C - Manual (Page 34)

PS5000C Operator’s Manual
3-8
2.2 Shading adjustment
Perform the “Shading” adjustment for correction of uneven lighting of the original.
Start the following adjustment procedure after at least 10 minutes elapse from
when the illumination of this unit was initiated.
1 On the book table, place the test chart for adjustment.
2 In the Adjustment area, select “1. Shading”, and click the “Start” button.
3 The following dialog appears. Click the “OK” button to start the adjustment.
4 When the screen indicating adjusting disappears, the “Shading” adjustment is
completed.
5 In order to complete the shading process, the “White Balance” adjustment
must be completed.
Adjustment table,
11×17-sized plain
white paper
50 mm (2 inch) blocks
Adjustment table
Position the adjustment table based on the center of the original.
50 mm (2 inch) blocks
Center of the original