Konica Minolta PS5000C - Manual (Page 28)

PS5000C Operator’s Manual
3-2
1 Installation
The PS5000C Twain Driver hereinafter referred to as “the Driver” must be installed on the personal
computer connected to the Scanner to read images from it. This chapter describes the system
requirements of the personal computer and the installation procedures of the Driver.
1.1 System environment
The following are the minimum system requirements for the computer connected
to the Scanner to install the Driver. The operator should be completely familiar
with basic Windows operations.
Computer Compatible with IBM PC/AT
OS WindowsXP HOME Edition/Professional
Windows2000
Required CPU/memory Required CPU: Pentium 4 2.8GHz or more
Required memory: 1GB or more
Application software Application software compatible with Twain32
(32-bit application compatible with Windows XP/2000)
Recommended SCSI
Host Adapter The following SCSI Host Adapter manufactured by Adaptec
(AHA-2940AU, AHA-2930U)
1.2 Installation procedure
The following procedure shows the driver installation for Windows XP.
Administrative rights are needed for the driver installation.
Note: Screens may differ slightly depending on the Windows version.
1 Check that the power switches of the Scanner and the personal computer are
turned off.
NOTE ! Turn on the power switch of the Scanner after installing the Driver.
2 Set the SCSI ID Switch on the backside of the Scanner to 0 to 6. (Default
setting value is 3)
3 Connect the Scanner to the personal computer with the SCSI cable.
4 Turn on the power switch of the personal computer, and start the Windows.
NOTE ! Do not turn the power switch of the Scanner ON at this time.