Konica Minolta bizhub 20P - Manual (Page 15)

About this Printer
5
1
Positioning the printer
1
Read the following before you use the printer.
Power supply
1
Use the printer within the recommended power range.
The power cord, including extensions, should be no longer than 5 meters (16.5 feet).
Do not share the same power circuit with other high-powered appliances, such as an air conditioner, copier,
shredder and so on. If you cannot avoid using the printer with these appliances, we recommend that you use
a voltage transformer or a high-frequency noise filter.
Use a voltage regulator if the power source is not stable.
Environment
1
„ Put your printer on a flat, stable surface such as a desk that is free of vibration and shocks.
„ Put the printer near an AC power outlet, so that it can be easily unplugged from the AC power outlet if there
is an emergency.
„ Only use the printer within the following ranges of temperature and humidity:
Temperature: 10 °C to 32.5 °C (50 °F to 90.5 °F)
Humidity: 20% to 80% (without condensation)
„ Use the printer in a well-ventilated room.
„ DO NOT put the printer where the ventilation hole of the printer is blocked. Keep a gap of roughly 100 mm
(4 in.) between the ventilation hole and the wall.
„ DO NOT expose the printer to direct sunlight, excessive heat, moisture, or dust.
„ DO NOT put the printer near devices that contain magnets or produce magnetic fields.
„ DO NOT expose the printer to open/naked flames or salty or corrosive gasses.
„ DO NOT put objects on top of the printer.
„ DO NOT put the printer near heaters, air conditioners, water, chemicals or refrigerators.
„ Keep the printer horizontal when you carry it.
Power source: USA and Canada: AC 110 to 120 V, 50/60 Hz
Europe and Australia: AC 220 to 240 V, 50/60 Hz