Konica Minolta bizhub C250 - Manual (Page 73)

2 Using copy functions
2-36 C250
Using copy f
unct
ions
Chapter 2
*1
If paper other than the specified paper size is
loaded, a paper misfeed may occur since the paper
size is not automatically detected.
*2
In order to specify a custom paper size in Enlarge
Display mode, the custom paper size must first be
stored before entering Enlarge Display mode. For
details, refer to the User’s Guide [Copy Operations].
*3
Wide paper is a size larger than the standard size
and allows copies of standard-sized documents to
be printed so that there is no loss at the edges. For
example, if 11×17 Wide paper is used, an area up to
12-1/4 in. × 18 in. can be printed, allowing the entire
area of an 11×17-size document to be printed.
The following procedure describes how to specify the
size of the paper loaded into the 1st tray.
Metric
*1
A metric paper size can be set so that the
paper tray is used specifically with the
selected paper size.
This is useful when the size of the paper that
is loaded cannot be automatically detected.
Other Papers
*1
Paper in a size other than metric or inch sizes
can be set so that the paper tray is used
specifically with the selected paper size. This
is useful for specifying a paper size that
cannot be detected automatically.
Setting Description