Konica Minolta bizhub C451 - Manual (Page 90)

Transmission 2
C451 2-47
2.11 When unable to send fax
When IP address fax is used, if the fax cannot be sent because the recipi-
ent’s line was busy, it can be transmitted again by using the redial function.
The redial function of this function has auto redial, manual redial.
2
Note
The destination cannot be changed with auto redial or manual redial in
the Current Jobs list.
Even after redialing, when the fax cannot be sent because of problems
with the line, refer to “Fax cannot be sent (IP Address Fax)” on page 4-4.
There is no E-mail resending function in internet fax. When you cannot
send a fax, refer to “Fax cannot be sent (Internet Fax)” on page 4-2.
Redial
Dialing again at the same destination is known as redial.
When fax cannot be sent since the line of recipient’s fax machine is busy, the
number is redialed after the lapse of the specific period. Before redialing, the
sent job is treated to be job queued of the redial stand by.
Auto redial function
When it is unable to send the fax because the recipient’s line is busy, it is au-
tomatically redialed as per the auto redial function, which is set through the
Line Parameter Settings.
!
Detail
In advance, the number of auto redials is specified as 3 times for 3 min-
utes in European models, 1 time for 3 minutes in North American models.
Refer to “Specifying Transmission/Reception Mode (Line Parameter Set-
tings)” on page 9-76 for the auto redial frequency settings.
Redial confirmation screen
When the fax cannot be sent due to the problem in the recipient’s fax ma-
chine, the screen to confirm redial is displayed.