Konica Minolta bizhub 160 - Manual (Page 43)

3 3.5 Turning the Machine On/Off and the Initial Mode
3-12 bizhub 160
B
e
fo
re
Ma
ki
ng
C
o
pi
es
Chap
ter
3
3.5 Turning the Machine On/Off and the Initial Mode
Turning the Machine On/Off
To turn on the machine:
➜ Press the | (on) side of the Power
Switch.
To turn off the machine:
➜ Press the 2 (off) side of the Power
Switch.
✎
Note
Do not turn off the machine while a copy cycle is being performed, as a paper
misfeed will result. Before attempting to turn off the machine, always be sure
that the current copy cycle has been completed.
Turning off the machine will initialize all settings except those for previously
programmed jobs and for the Utility mode.
The machine automatically enters the Energy Save mode 15 min after the last
operation is performed.
The time until the machine enters Energy Save mode can be specified from the
Utility mode. For details, refer to “Specifying the Setting for “ENERGY SAVE
MODE”” on page 5-5 in the chapter “Using the Utility Mode”.
When the Machine is Turned On
When the machine is turned on, the [Start] key indicator lights up in orange to
indicate that the machine is ready to begin copying.
At this time, the machine can be set for the Auto Copy Start function by loading a
document into the Automatic Document Feeder or by placing a document on the
Original Glass, and pressing the [Start] key.
Pressing the [Start] key at this time will not immediately start the copy cycle. You
will have to wait for less than 25 seconds (at an ambient temperature of 73.4°F).