Konica Minolta BIZHUB C253 - Manual (Page 27)

C253/C203 2-16
Administrator Operations 2
4
Touch [OK].
? What if an Administrator Password different from that is currently registered is mistakenly entered?
% If there is a mismatch between the currently registered Administrator Password and the Administra-
tor Password entered, a message appears that tells that there is a mismatch in the Administrator
Passwords. Enter the correct Administrator Password.
% If Prohibited Functions When Authentication Error is set to [Mode2], entry of a wrong password is
counted as unauthorized access. If a wrong Administrator Password is entered a predetermined
number of times (once to five times) set by the Administrator of the machine, the Utility screen ap-
pears and the machine is set into an access lock state. To cancel the access lock state, settings
must be made by the Service Engineer; or, turn off, and then turn on, the main power switch of the
machine. If the main power switch is turned off and on, the access lock state is canceled after the
lapse of time set for [Release Time Settings]. When the main power switch is turned off, then on
again, wait at least 10 seconds to turn it on after turning it off. If there is no wait period between
turning the main power switch off, then on again, the machine may not function properly.
Here is the sequence, through which the main power switch and sub power switch are turned on
and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn on the main power switch →
Turn on the sub power switch
5
Enter the new 8-digit Administrator Password from the keyboard and keypad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the Security Settings screen.
6
Touch [OK].
7
To prevent entry of a wrong Administrator Password, enter the new 8-digit Administrator Password
once again.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.