2 switching to power save mode, Switching to power save mode -7 – Konica Minolta bizhub C3110 User Manual
Page 39
bizhub C3110
3-7
3.2
About Power Supply
3
3.2.2
Switching to Power Save mode
Hold down the Scan/Sleep or Copy/Power key to switch this machine to Power Save mode.
When each key is held down, the status of this machine changes as shown below.
Tips
If this machine is switched to Sleep mode in factory settings, it automatically shifts to Deep Sleep mode that
reduces power consumption further than when in Sleep mode.
However, this machine cannot be shifted to Deep Sleep mode if:
-
An optional i-Option LK-111 is employed and the ThinPrint function is enabled.
-
An optional Authentication Unit is connected.
Related setting (for the administrator)
When this machine is in Sleep mode, you can select whether or not to shift to Deep Sleep mode that reduces
power consumption further than when in Sleep mode.
To configure settings: [UTILITY] - [Admin Settings] - [System Settings] - [Pwr Sup/Pwr Sav] - [SleepMdPwr-
Consump] (Default: [Enabled])
Key
Status of
this ma-
chine
Status of
Start Indi-
cator
Print / Fax
RX
Description
Scan/Sleep
Sleep
Flash: Blue
Enable
Turns off the backlight of the Message
Window to reduce power consumption.
If a fax or print job is received, it is print-
ed while Sleep mode is maintained in
the active state.
Operating the Control Panel returns to
Normal mode.
Deep Sleep
Flash: Blue
Enable
Reduces power consumption further
than when in Sleep mode.
The display of the Message Window is
turned off completely.
If a fax or print job is received, this ma-
chine shifts to Sleep mode to make
prints, then returns to Deep Sleep
mode.
The time required to return to Normal
mode is longer than that required to re-
turn from Sleep mode.
Operating the Control Panel returns to
Normal mode.
Copy/Pow-
er
ErP Auto
Power OFF
Flash:
Orange
Disable
This function provides a more signifi-
cant power saving effect than Deep
Sleep mode, which is close to the state
where the main power is turned off.
To enable the machine to return to Nor-
mal mode from the ErP Auto Power OFF
status, press the Copy/Power key
again.