2 safety information, Warning and precaution symbols, Power source connection – Konica Minolta bizhub C3110 User Manual
Page 11
bizhub C3110
1-5
1.2
Safety information
1
1.2
Safety information
This section contains detailed instructions on the operation and maintenance of this machine. To achieve op-
timum utility of this device, all operators should carefully read and follow the instructions in this manual.
Please read the following section before connecting the machine to the supply. It contains important infor-
mation related to user safety and preventing equipment problems.
Please keep this manual in a handy place near the machine.
Make sure that you observe all of the precautions that appear in different sections of this manual.
KM_Ver.08_OE
Reference
-
Some parts of the contents of this section may not correspond with the purchased product.
Warning and precaution symbols
Be sure to observe the safety precautions.
This manual contains the instructions that should be strictly observed at all times to prevent injury to yourself
and other persons as well as damage to property.
Injuries and damage that might be caused by using the product improperly are classified according to the
following symbols.
These are some of major exemplary graphical symbols
Power source connection
Pictorial indication
Description
WARNING
Improper handling can cause serious injury or death.
CAUTION
Improper handling can cause minor injury or damage to houses and
property.
Graphic
symbols
Descriptions
Graphic
symbols
Descriptions
Graphic
symbols
Descriptions
General prohibition
Do not disassemble
Do not touch
General instruction
Ground/Earth
Unplug from outlet
General precaution
High temperature
Electrical shock
hazard
WARNING
Use only the power cord supplied in the package. If a power cord is not
supplied, use only the power cord and plug that are specified in the user
documentation. Failure to use this cord could result in a fire or electrical
shock. If the power cord supplied in the package cannot be used in the
country where this product was sold, use a power cord that meets the
following conditions or contact your Technical Representative.
•
The power cord has voltage and current rating appropriate for the rat-
ing plate on this machine.
•
The power cord meets regulatory requirements for the area.
•
The power cord is provided with grounding pin/terminal.
Do not use the power cord to other products. Failure to do that could re-
sult in a fire or electrical shock.