Apple iMac G5 - Manual (Page 52)

52 Chapter 4 Enhancing Your Computer
9 Turn the three captive screws clockwise to tighten them. Be careful not to over-tighten
the screws, as you may strip the screw heads.
10 Holding each side of the computer, gently turn the computer right side up. Then
reconnect the cables and power cord you disconnected from your computer.
11 Press the power button on the back of your computer to turn it on.
Note: Replacing the battery may cause some settings on your computer, such as date
and time, to revert to the factory default settings. You may also have to restore modem
settings in any communications programs you use.
Dispose of the old battery following the instructions in “Disposal and Recycling
Information” on page 84.
· Warning: The ambient light sensor is located to the left of the middle screw, as
shown in the illustration. Don’t mistake the ambient light sensor for a screw. Sticking
a screw driver or other sharp object in the ambient light sensor could damage your
computer.
Warning: Operating the computer when it is open or missing parts can be dangerous
and could damage your computer.
Raise
stand Phillips
screwdriver
Tighten 3
screws
Screw
Ambient
light sensor