Lenovo THINKSTATION D10 - Manual (Page 40)

Replacing the diskette drive or card reader
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
This section provides instructions on how to replace the diskette drive or card
reader.
1. Open the computer cover. See “Opening the cover” on page 12.
2. Remove the front bezel. See “Removing the front bezel” on page 14.
3. Locate the drive cable connectors. See “Identifying parts on the system board”
on page 9.
4. Note the location of the drive cables. Disconnect the drive cables from the
system board.
5. Press the drive latch 1 and slide the drive or card reader from the chassis.
See Figure 23.
6. Disconnect the flat cable from the rear of the failing diskette drive.
7. Connect the flat cable to the new diskette drive.
8. Install the new drive into the drive-bay assembly and lock the drive into
position.
9. Go to Chapter 4, “Completing the parts replacement,” on page 39.
Figure 23. Removing the diskette drive or card reader drive
32 ThinkStation Hardware Installation and Replacement Guide