Lenovo THINKSTATION D10 - Manual (Page 22)

Removing the front bezel
To remove the front bezel:
1. Remove the cover, see “Opening the cover” on page 12.
2. Disengage the bezel latches 1 , one at a time while rotating the bezel away
from the computer just enough to keep the latches disengaged. See Figure 6.
3. Lay the front bezel on a flat surface.
4. Reverse these steps to replace the front bezel.
Accessing system board components and drives
To access system board components:
1. Open the computer cover. See “Opening the cover” on page 12.
2. Unlatch and open the adapter card retainer.
3. Take note of the location of all cable connections on the adapter cards. It will be
necessary to reconnect them properly when replacing the cards.
4. Disconnect all cables connected to the adapter cards. See “Identifying parts on
the system board” on page 9.
5. Remove the hard disk drive fan and bracket (some models).
6. Remove the card retaining screw, if one is used.
7. Release the card support retaining latches. Grasp the adapter card and pull the
card out of the slot. See “Replacing an adapter card” on page 26 for more
information.
Note: The card is a tight fit, so it might be necessary to remove each side a
little at a time until the card is removed from the card slot.
Figure 6. Removing the front bezel
14 ThinkStation Hardware Installation and Replacement Guide