Lenovo THINKSTATION S10 - Manual (Page 47)

Replacing the internal speaker
Attention
Do not open your computer or attempt any repair before reading the “Important safety
information” in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at:
http://www.lenovo.com/support/
This section provides instructions on how to replace the internal speaker.
1. Open the computer cover. See “Opening the cover” on page 12.
2. Remove the front bezel. See “Removing the front bezel” on page 14.
3. Locate the internal-speaker connector on the system board. See “Locating
internal components” on page 8.
4. Note the location of the internal-speaker cable connection. Note the routing of
the internal-speaker cable. Disconnect the internal-speaker cable from the
system board. See “Identifying parts on the system board” on page 9.
5. Use a blunt instrument (such as, the top of a ball point pen) to disengage one
of the internal-speaker-locking tabs 2 and slide that side of the speaker 1
upward enough to keep the locking tab disengaged. Then disengage the other
internal-speaker-locking tab and slide the internal speaker upward until the
speaker is released.
6. Remove the speaker and speaker cable from the computer.
Figure 28. Removing the internal speaker
Chapter 3. Installing options and replacing hardware 39