Lenovo ThinkServer TS430 - Manual (Page 152)

10. Connect the appropriate power cable 1 and the SATA signal cable 2 to the rear of the non-hot-swap
hard disk drive.
Figure 77. Connecting cables to the rear of the non-hot-swap hard disk drive
The following table provides information about the recommended power connector and system
board SATA connector for the non-hot-swap hard disk drive installed in each drive bay. See “Server
components” on page 25 and “System board components” on page 45 for the location information
about the hard-disk-drive bays and SATA connectors on the system board.
Non-hot-swap hard disk drive Power connector System board SATA connector
Installed in bay 0 P9 power connector SATA connector 0
Installed in bay 1 P10 power connector SATA connector 1
Installed in bay 2 P7 power connector SATA connector 2
Installed in bay 3 P8 power connector SATA connector 3
11. Connect the other end of the SATA signal cable to the appropriate SATA connector on the system board.
See “System board components” on page 45.
12. Reinstall the front system fan 1. See “Replacing the front system fan” on page 157.
140 ThinkServer TS430 User Guide