Lenovo ThinkServer TS430 User Manual

Page 122

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.

Notes:

• If you remove the TR 700 Battery, you will lose the backup power for the ThinkServer RAID 700 Adapter.

• Use any documentation that comes with the TR 700 Battery and follow those instructions in addition to

the instructions in this topic.

To remove the TR 700 Battery, do the following:

1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all

power cords from electrical outlets and disconnect all cables that are connected to the server.

3. Lay the server on its side for easier operation.

4. If a PCI card bracket assembly is installed in your server, remove the PCI card bracket assembly. See

5. Locate the ThinkServer RAID 700 Adapter, which is located in the PCI-E slot 3 on the system board.

6. Remove the ThinkServer RAID 700 Adapter, which is a kind of RAID card. See “Installing or removing

7. Carefully remove the three screws that secure the TR 700 Battery and then remove the TR 700 Battery

from the ThinkServer RAID 700 Adapter.

Note: Center the screwdriver when you remove the screws to avoid possible damage to any parts.

Figure 52. Removing the TR 700 Battery from the ThinkServer RAID 700 Adapter

8. If you want to install a new TR 700 Battery, see “Installing the TR 700 Battery” on page 108.

9. Reinstall the ThinkServer RAID 700 Adapter with a new TR 700 Battery or without a TR 700 Battery. See

What to do next:

• To work with another piece of hardware, go to the appropriate section.

110

ThinkServer TS430 User Guide