Lenovo ThinkCentre A51 - Manual (Page 19)

Table 6. Options supported by the ThinkVantage Fingerprint Software (continued)
Parameter Description
PWDLOGON • 1 = Enable the fingerprint-only logon for
non-administrator users.
• 0 = Disable the fingerprint-only logon for
non-administrator users.
The default value is 1.
NOPOPPAPCHECK • 0 = Do not show the power-on security options.
• 1 = Always show the power-on security options.
The default value is 0.
CSS • 0 = Assume that Client Security Solution has not been
installed.
• 1 = Assume that Client Security Solution has been
installed.
The default value is 0.
Note: All options are optional.
To uninstall the Fingerprint Software, use the /x parameter instead of /i. During the standard uninstall from
the user interface, dialogs for selecting whether to delete existing passports and disable the boot security
feature are displayed. In the silent uninstall mode, you can use the DELPAS parameter. Set the DELPAS
value to "1" to delete existing passports. If these options are not defined, or have any other value, passports
are left on the computer and the boot security remains enabled. If you leave the boot security on, you will
not be able to edit fingerprints in the boot security memory unless you re-install the product. For example,
running the following syntax:
msiexec /i Setup.msi DELPAS="1" /q
would uninstall the product, delete all existing passports, and leave the boot security on the computer.
Installing Lenovo Fingerprint Software
The setup32.exe file of the Lenovo Fingerprint Software program can be installed by using the following
procedure.
Silent installation
To silently install the Fingerprint Software, run the setup32.exe file located in the installation directory
on your CD-ROM drive.
Use the following syntax:
setup32.exe /s /v"/qn REBOOT ="R""
To uninstall the software, use the following syntax:
setup32.exe /x /s /v"/qn REBOOT="R""
Options
The following options are supported by Lenovo Fingerprint Software.
Chapter 2 . Installation 11