Lenovo ThinkServer TD200 - Manual (Page 86)

1 EMC shield
2 Tape drive
5. If the tape drive comes with screws, secure the tape drive to the chassis with
the supplied screws.
6. Connect one of the connectors on the optical drive power cable to the tape
drive.
Note: If you are installing an RDX internal USB tape drive, use the
SATA-to-traditional power converter cable to serve as a bridge between the
optical power cable and the power connector on the RDX tape drive.
7. Connect one end of the tape drive signal cable to the tape drive and the other
end to the connector on the system board. Route the cable through the plastic
slots on the bottom of the chassis underneath the fan cage assembly as
shown in the following illustration:
68 ThinkServer TD200 Types 3724, 3808, 3809, 3815, 3817, 3824, 3826, 3836: Installation and User Guide