Kodak 605 - Manual (Page 14)

Setting Up the Printer
April 30, 2007 1-9
5. Carefully lower the paper roll into the slots. Match the geared flange
(green) with the geared slot (green) on the printer.
6. Remove the label from the paper roll.
NOTE: Verify that the paper unrolls from the top of the roll.
7. Feed the paper into the rear printer slot until the red LED light turns off
and the green LED light turns on.
8. Close the paper door.
NOTE: Ribbon must be loaded in the printer before the paper automatically
advances.
The printer advances the paper, then cuts and discharges 6 blank test
prints—about 24 in. (61 cm). This reduces the possibility of
fingerprints or other damage to the prints. It does not decrease the
750 4 x 6 in. (10 x 15 cm) print capacity of the paper roll.
The operator panel displays the Ready message.
IMPORTANT: You must empty the trim tray each time you change the
paper to keep your prints dust-free and to prevent paper
jams.
9. Empty and replace the trim tray.
Slot
Label