Kodak Printer Dock Plus User Manual
Page 33
Using the printer dock plus with a computer
www.kodak.com/go/support
27
Transferring pictures from the internal
SD/MMC card reader
1 Make sure Kodak EasyShare software is installed (see
) and the
printer dock is connected to your computer (see
).
2 Open the accessory door on the printer dock.
3 If a Kodak EasyShare camera is docked, remove it.
IMPORTANT: Insert card only as shown. Do not force the card into the card slot.
Do not insert or remove a card when the printer dock is transferring
pictures or if the USB device connector light is blinking.
4 Orient the card as shown, then push the card
into the SD/MMC card slot to seat the
connector.
The SD/MMC card slot light blinks while the
printer dock reads the card.
5 Press the Transfer button,
, on the printer
dock.
Kodak EasyShare software opens on your
computer (if it is installed).
6 Use Kodak EasyShare software to transfer pictures from the printer dock to
your computer. See the Kodak EasyShare software Help for details.
The printer dock Transfer light blinks while the pictures are being transferred.
The Transfer light continues to blink until the Transfer or Print button is pressed,
or until the connection times-out.
NOTE: With the software installed, connecting the printer dock to the computer establishes a new
drive connection for the internal card reader. Pressing the Transfer button lets you view,
copy, delete, and otherwise manage files on the new drive, as you do with other drives on
your computer. See your computer documentation for details.
■
To stop transfer, press the Cancel button,
.
To remove the card, pull it out.
Notched corner