American Audio Pro Scratch 1 - Manual (Page 24)

BASIC OPERATIONS - FX MIX
FX MIX - FADE CONTROL: This function works with the FLANGER/ECHO and the TRANS/PAN effects. This
function uses the time duration of the FADE effect. This functions plays the selected effect (FLANGER/ECHO
and/or the TRANS/PAN) for the duration of the fade setting and then returns to normal play. During this function
the FADE effect will have no function other than the use of its time parameter - the track will not fade out.
The procedure below list the steps to activate the FX Mix - Fade Control. In the following example we will
you the FLANGER and the TRANS effects.
American DJ
®
AUDIO • Pro Scratch 1™ INSTRUCTION MANUAL • PAGE 24
STEP ONE: Be sure you are in continuous play mode, and a track is playing.
Turn the FADE effect on. By pressing holding down the SCRATCH/FADE
BUTTON (4) until it begins to flash as in figure 52.
Figure 52
Figure 56
Figure 55 Figure 54
Figure 53
STEP TWO: Select the FX MIX BUTTON (11) to activate the FX Mix Mode as
in figure 53.
STEP FOUR: To initiate the FX FADE Function, tap the BOP/ENTER BUTTON
(20). At this point the effects will play out for the length of the FADE value. When the
effect has played out normal playback will resume from the point the effect ended.
You must be in continue mode for this effect to operate properly, if the unit is in single
play mode the track will cue when the effect has played out.
STEP THREE: After you have activated FX Mix
Mode, select an effect. In this example we will choose
the FLANGER and TRANS Effects.