MyWeigh DuraScale - Manual (Page 5)

6) Press ‘TARE’ , the ‘0’ in ‘CAL-0’ will flash
When the calibration is finished, the scale will automatically turn off/reset NOTE: if after calibration
your scale does not read accurately, this indicates
calibration error and the calibration process should be repeated more slowly.
Please calibrate on a very stable flat surface
INACCURACY / ERROR___________________________________
The primary reasons for inaccuracy or malfunction are low batteries, incorrect calibration, air
movement, overload or operating on an unstable surface. Please keep this in mind and maintain and
operate your scale properly. The scale is a precise instrument and must be handled with the utmost care
and caution.
* Overload
When an applied load exceeds the capacity." ------" will appear on the display. Remove the excessive
load immediately!
!Remember: You can permanently damage the scale by overloading it!
* Negative Value
Any tared value or a value left in memory will be displayed as a negative number once all weight is
removed from the unit. Press tare to re-Zero the unit.
* Auto off
An adjustable auto shut off feature is provided to conserve battery power. To program the auto-off time
please follow these instructions:
1) Starting with the scale powered off, press and hold both the ‘ON/OFF’ and ‘PCS’ keys until ‘A.OFF.x’ is
shown, (x=1,2,or 3,) , this means the auto-off time is 1,2 or 3 minutes).
2) Press ‘PCS’ , the value for ‘x’ will change and flash.
3) When you have set the desired value for the auto-off time, press ‘TARE’ to save the setting and then
press ‘ON/OFF’ to exit the auto off time programming mode
* DISPLAY DATA HOLD (LOCK) FUNCTION SET