MyWeigh MBS 2010 - Manual

MBS-2010 Baby Scale Manual
Low Batteries & Faulty AC Adaptors are the #1 cause of scale malfunction and inaccuracy! We
test all of our scale returns from consumers. Fully 60% of consumer returns are simply dead or low
batteries. This sounds silly but it's true! A scale will perform slowly, or read inaccurately when it has
low batteries. Please replace the batteries often (and only use good quality batteries). We include
good quality batteries with all of our scales but batteries can run low in storage. A Faulty AC adaptor
can cause your scale to act unstable with numbers "jumping" all around. Please test your scale with a
good set of batteries (instead of the AC adaptor) to determine if perhaps the AC adaptor is faulty.
1. Install 9V Alkaline Battery into battery compartment or connect with an AC Adapter
To install the battery, remove the battery cover on the underside of the scale. Install a 9volt
battery and push the connector firmly onto the battery terminals. Reinstall the cover. To use the
optional AC adapter, Plug the AC adapter into the jack on the right side of the scale.
The scale has an Auto-off feature that will turn the scale OFF after a few minutes of inactivity to
conserve power.
2. The Process of Weighing
A. Install the tray onto the scale with its 2 screws (if you need the tray).
B. Press the "ON/ OFF/TARE" button.
C. The display will momentarily show "8888".