MSI Keeper 945GME V2.0 - Manual (Page 54)

3-16
M S-9641 M ainboard
cations/files is saved to main memory that remains
powered while most other hardware components turn
off to save energy. The information stored in memory
will be used to restore the system when a
“wake up”
event occurs.
Soft-Off by PWR-BTTN N
This feature allows users to configure the power button function. Settings are:
[Instant-Off] The power button functions as a normal power-on/-off button.
[Delay 4 Sec.] W hen you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Wake-Up by PCI Card
W hen setting to [Enabled], this setting allows your system to be awakened from
the power saving modes through any event on PCI PME (Power Management
Event).
USB KB Wake-Up from S3
This setting allows you to enter “Any Key” (max. 8 numbers) to wake up the
system from S3 state.
Resume by Alarm
W hen [Enabled], your can set the date and time at which the RTC (real-time
clock) alarm awakens the system from suspend mode.
Date (of Month) Alarm
W hen Resume By Alarm is set to [Enabled], the field specifies the month for
Resume By Alarm.
Time (hh:mm:ss) Alarm
You can choose what hour, minute and second the system will boot up.
PWRON After PWR-Fail
This item specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Off] Leaves the computer in the power off state.
[On] Leaves the computer in the power on state.
[Former-sts] Restores the system to the status before power fail-
ure or interrupt occurred.
Boot Up NumLock Status
This setting is to set the Num Lock status when the system is powered on. Setting to
[On] will turn on the Num Lock key when the system is powered on. Setting to [Off]
will allow users to use the arrow keys on the numeric keypad.
Auto Detect PCI Clk
This item is used to auto detect the PCI slots. W hen set to [Enabled], the system will