Atlantis DISKMASTER NAS65020 - Manual (Page 29)

29
2.1 SYSTEM->Networking Management
NetWork Settings
These settings help DiskMaster connect to the network
 IP Status: The default value is Automatically (DHCP). In this way the
DiskMaster is configured as DHCP clients. Check the Manual Configuration
to set the IP address manually.
 Host Name: While the name is changeable to administrator’s favorite, the
use of “DiskMaster” can help you to memorize how you create your own
FQDN (Fully Qualified Domain Name).
 Domain Name: The domain name of DiskMaster registers to the internet or
the domain name of the internet ISP. It helps you to memorize how you
create your own FQDN (Fully Qualified Domain Name).
 Primary/Slave DNS: Enter the IP addresses used by DiskMaster to resolve
names (this field is active when Status is set to Manual IP Configuration).
 Physical Address: Shows the MAC address of DiskMaster’s LAN.
 LAN IP Address: Enter the IP address by DiskMaster (this field is active
when IP Status is set to Manual Configuration).
 Subnet Mask: Enter the subnet mask (this field is active when IP Status is
set to Manual Configuration)
 Gateway: The address of the “Gate” which is placed at the junction of the
LAN and internet such as Router, AP, or IP Share. They serve as the
communication between the internet and the LAN.
After entering the parameters click Save to make permanent the configuration.