FMI IDS - Manual (Page 9)

IDS INDUSTRIAL DISPENSER
INSTRUCTIONS
9
Interchangeable pumphead modules permit this industrial dispenser to be
FLOW RANGE
IDS FLOW INFORMATION
Interchangeable pumphead modules permit this industrial dispenser to be
60
100
100
100
5
15
(PSIG) MAX
PRESSURE
60
0 - 320 1000 0.32 Q1 (1/4)
Q2 (3/8)
Q3 (1/2)
operated in any of four flow rate ranges.
RH00 (1/8)
RH1 (1/4)
RH0 (3/16)
operated in any of three flow rate ranges.
900
800
0 - 100
0 - 25
0 - 50
1000
1000
1000
0 - 1000
0 - 650
0.025
0.100
0.050
0.72
1.28
Q0 (1/8)
PISTON
MAXIMUM
1000
RPM
mL/MIN
0 - 80
STROKE
0.08
MAX mL PER
SIZE
If a TIMED/COUNTED dispense is run, the pump will stop at the point of signal turn off. It will NOT
continue to complete the interrupted revolution. The pump will only complete the cycle if a single Start
command is given or as part of the next TIMED /COUNTED cycle.
6.0 Dispense / Flow Rates
To avoid cavitation at maximum speed use maximum internal diameter tubing at the suction side. Cavita-
tion produces noise and inaccuracies of flow.
See 7.0 Calibration
1
IN-IDS-08