Cirrus Logic CDB48500-USB - Manual (Page 10)

1
Chapter 2
Board Setup and Installing the Evaluation Kit Software
2.1 Introduction
It is important to install the Evaluation Software BEFORE connecting the USB cable from the PC to the
CDB USB MASTER card. Failure to install the evaluation software before the initial connection can result
in an inability to communicate with the CBD485xx.
2.1.1 Installing the Evaluation Kit Software
The DSP evaluation software installation will first install the Cirrus Logic DSP evaluation software followed by
the USB drivers required to communicate with the CDB USB MASTER.
1. Run the latest DSP evaluation software installation executable (CS485xx_eval_kit_rcnumber>.exe ). This executable is supplied by your Cirrus Logic representative.
2. At the Welcome screen, click Next.
3. At the Licensing Agreement window, select the “I accept the agreement” radio button to agree to the
terms and then select Next.
4. Select the Destination Location window, Select the default location “C:\CirrusDSP” and click Next.
5. Select Start Menu Folder window, Select the default location “C:\CirrusDSP” and click Next.
6. The Ready to Install window indicates the selected destination location and the Start menu folder for
confirmation, select Install to begin the install process which should take less than one minute.
7. After the DSP evaluation software is installed, the installer will launch the Front Panel Driver Setup Wizard
(below). Click Next to continue the installation.
Figure 2-1. CDB USB MASTER Driver Setup