Figure 10. control port timing, spi mode, 10 memory address pointer (map), 1 incr (auto map increment enable) – Cirrus Logic CS4351 User Manual
Page 22: 2 map (memory address pointer), Figure 10.control port timing, spi mode, Section 4.10.2, Figure 10, Cs4351
22
DS566F1
CS4351
4. Write the desired data to the register pointed to by the MAP.
5. If the INCR bit (see
) is set to 1, repeat the previous step until all the desired registers
are written, then bring CS high.
6. If the INCR bit is set to 0 and further SPI writes to other registers are desired, it is necessary to bring
CS high, and follow the procedure detailed from step 1. If no further writes to other registers are de-
sired, bring CS high.
)
4.10
Memory Address Pointer (MAP)
4.10.1
INCR (AUTO MAP INCREMENT ENABLE)
Default = ‘0’
0 - Disabled
1 - Enabled
4.10.2
MAP (MEMORY ADDRESS POINTER)
Default = ‘0000’
7
6
5
4
3
2
1
0
INCR
Reserved
Reserved
Reserved
MAP3
MAP2
MAP1
MAP0
0
0
0
0
0
0
0
0
MAP
M SB
LSB
DATA
byte 1
byte n
R/W
M AP = M em ory Address Pointer
ADDRESS
CHIP
C DIN
CC LK
CS
1001100
Figure 10. Control Port Timing, SPI mode