Cirrus Logic CDB5378 - Manual (Page 12)

CDB5378
12 DS639DB4
CDB5378 as an unknown USB device.
• If prompted for a USB driver, skip to the next step. If not, using Windows Hardware Device Manager
go to the properties of the unknown USB API device and select “Update Driver”.
• Select “Install from a list or specific location”, then select “Include this location in the search” and then
browse to “C:\Program Files\Cirrus Seismic Evaluation\Driver\”. The PC will recognize and install the
USBXpress device driver.
• After driver installation, cycle power to CDB5378. The PC will automatically detect it and add it as a
USBXpress device in the Windows Hardware Device Manager.
An application note, AN271 - Cirrus Seismic Evaluation GUI Installation Guide, is available from the Cirrus
Logic web site with step-by-step instructions on installing the USBXpress driver.
1.3.4 Launching the Seismic Evaluation Software
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
To launch the Cirrus Seismic Evaluation Software, go to:
• Start
Ö
Programs
Ö
Cirrus Seismic Evaluation
Ö
Cirrus Seismic Evaluation
or:
• C:\Program Files\Cirrus Seismic Evaluation\SeismicGUI.exe
For the most up-to-date information about the software, please refer to its help file:
• Within the software: Help
Ö
Contents
or:
• C:\Program Files\Cirrus Seismic Evaluation\SEISMICGUI.HLP