3 software setup, 1 pc requirements, 2 seismic evaluation software installation – Cirrus Logic CDB5378 User Manual
Page 11: 3 usbxpress driver installation, Cdb5378
CDB5378
DS639DB4
11
1.3
Software Setup
1.3.1
PC Requirements
The PC hardware requirements for the Cirrus Seismic Evaluation system are:
• Windows XP, Windows 2000, Windows NT
• Intel Pentium 600MHz or higher microprocessor
• VGA resolution or higher video card
• Minimum 64MB RAM
• Minimum 40MB free hard drive space
1.3.2
Seismic Evaluation Software Installation
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
To install the Cirrus Logic Seismic Evaluation Software:
• Go to the Cirrus Logic Industrial Software web page (
). Click
the link for “Cirrus Seismic Evaluation GUI” to get to the download page and then click the link for “Cir-
rus Seismic Evaluation GUI Release Vxx” (xx indicates the version number).
• Read the software license terms and click “Accept” to download the “SeismicEvalGUI_vxx.zip” file to
any directory on the PC.
• Unzip the downloaded file to any directory and a “Distribution\Volume1” sub-folder containing the in-
stallation application will automatically be created.
• Open the “Volume1” sub-folder and run “setup.exe”. If the Seismic Evaluation Software has been pre-
viously installed, the uninstall wizard will automatically remove the previous version and you will need
to run “setup.exe” again.
• Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard. The default in-
stallation location is “C:\Program Files\Cirrus Seismic Evaluation”.
An application note, AN271 - Cirrus Seismic Evaluation GUI Installation Guide, is available from the Cirrus
Logic web site with step-by-step instructions on installing the Seismic Evaluation Software.
1.3.3
USBXpress Driver Installation
Important: For reliable USB communication, the USBXpress driver must be installed after the Seismic
Evaluation Software installation but before launching the application. The USBXpress driver files are in-
cluded in a sub-folder as part of the installation.
The Cirrus Logic Seismic Evaluation Software communicates with CDB5378 via USB using the USBX-
press driver from Silicon Laboratories (
). For convenience, the USBXpress driver
files are included as part of the installation package.
To install the USBXpress driver (after installing the Seismic Evaluation Software):
• Connect CDB5378 to the PC through an available USB port and apply power. The PC will detect