Next Advance SP2200 User Manual
Page 21
NEXT>>>ADVANCE
www.nextadvance.com
SP2200Programmable Syringe
Pump
Publication #1200-02
16
04/29/10
When triggered, the current operation of the pump and the Pumping Program is interrupted, and the Pumping
Program immediately continues operation (jumps to) with Phase number ‘nn’, specified with the “FUN EVN”
function, executed prior to the execution of the “FUN EVE” function. After being triggered, the event trigger
is reset. If an event trigger function is executed while another event trap is still set, the new event trigger will
replace the previous event trap.
The following example, sets an event trap at the start of a Pumping Program to jump to Pumping Program
Phase 5 when a falling edge occur on expansion port pin 3.
PHN 1
FUN EVN 5
PHN 2
FUN EVE 3
7.3.16 Setup Expansion Port Pause and Trigger Level Wait Phase
Command: “FUN EPL
Pauses the Pumping Program and waits for a trigger on Expansion Port pin
detection of a high to low TTL transition on the specified pin, or a low level when the function is first executed.
7.3.17 Setup Expansion Port Pause and Trigger Edge Wait Phase
Command: “FUN EPE
Pauses the Pumping Program and waits for a trigger on Expansion Port pin
detection of a high to low TTL transition on the specified pin.
7.3.18 Event Reset
Command: "FUN EVR"
’Event Reset’ cancels a previously set event trap.
7.3.19 Override Operational Trigger Default Configuration
Command: “FUN TRG
Sets the Operational Trigger (pin 2) to mode setting
Configuration. See Sec. 6.5, ‘TTL I/O Operational Trigger Default Configuration’, for the settings for
parameter
7.3.20 Set TTL Output Pin
Command: "FUN OUT n"
Set ‘Program Output’ TTL I/O output (pin 5) to level ‘n’.
If ‘n’ = 0, the output pin will be set low. If ‘n’ = 1, the output pin will be set high.
7.3.21 Set TTL Expansion Port Output Pin Low
Command: "FUN OE0
Set expansion port pin
7.3.22 Set TTL Expansion Port Output Pin High
Command: "FUN OE1
Set expansion port pin
7.3.23 Beep
Command: "FUN BEP"