Kramer Electronics VP-790 - Manual (Page 23)

VP-790 Warp Generator – Preparing a Grid 21
5.4
12B
Uploading the Warp Map to the VP-790
To update or upload the Warp Map onto the VP-790, you need to connect it to your
PC. To do so:
• Connect the PC to your VP-790 via the Ethernet (see
U
Section 5.4.1
U
)
• Connect to the VP-790 via the Warp Generator software (see
U
Section 5.4.2
U
)
• Upload the Warp file (see
U
Section 5.4.3
U
)
5.4.1
16B
Connecting via the Ethernet
You can connect to the VP-790 via Ethernet using either of the following methods:
• Direct connection to the PC using a crossover cable (see
U
Section 5.4.1.1
U
)
• Connection via a network hub, switch, or router, using a straight-through cable
(see
U
Section 5.4.1.2
U
)
5.4.1.1
21B
Connecting the Ethernet Port Directly to a PC (Crossover Cable)
You can connect the Ethernet port of the VP-790 to the Ethernet port on your PC,
via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VP-790
with the factory configured default IP address.
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
U
Figure 21
U
).
i