1 connecting the ethernet port directly to a pc, Connecting the ethernet port directly to a pc – Kramer Electronics VS-66H3 User Manual
Page 17
Operating the VS-66H3 6x6 HDMI Matrix Switcher
KRAMER: SIMPLE CREATIVE TECHNOLOGY
14
To connect to the product via RS-232:
•
Connect the RS-232 9-pin D-sub on the rear panel of the VS-66H3
via a 9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5
to pin 5 need to be connected) to the RS-232 9-pin D-sub port on your
PC
7.6 Connecting to the VS-66H3 6x6 HDMI Matrix Switcher via
Ethernet
You can connect the VS-66H3 via the Ethernet, using a crossover cable (see
Section 7.6.1
) for direct connection to the PC or a straight through cable
(see
Section 7.6.2
) for connection via a network hub or network router
7.6.1 Connecting the Ethernet Port directly to a PC
.
You can connect the Ethernet port of the VS-66H3 to the Ethernet port on
your PC via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the
VS-66H3 during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. On your desktop, right-click the My Network Places icon.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button
(see
1 After connecting the Ethernet port, you have to install and configure your Ethernet Port. For detailed instructions, see the
“Ethernet Configuration (FC-11) guide.pdf” file in the technical support section