Kramer Electronics VS-66H3 User Manual
Page 10
Defining the VS-66H3 6x6 HDMI Matrix Switcher
7
Figure 2: VS-66H3 6x6 HDMI Matrix Switcher Rear Panel
Table 2: VS-66H3 6x6 HDMI Matrix Switcher Rear Panel Features
#
Feature
Function
13
OUTPUT HDMI Connectors (1 to 6)
Connect to up to 6 HDMI acceptors
14
INPUT HDMI Connectors (1 to 6)
Connect to up to 6 HDMI sources
15
RS-232 9-pin D-sub Serial Port Connector
Connect to a PC/serial controller
16
ETHERNET RJ-45 Connector
Connect to a PC via a LAN
17
ETH RESET Button
Press to reset to the factory default IP parameters
18
REMOTE IR Opening
Connect to an external IR receiver for controlling the device via an IR remote controller (see
Section
19
Mains Power Connector
Connect to the mains power
20
Mains Power Fuse
Fuse for protecting the device
21
Mains Power Switch
Switch for turning the device on or off
1 First turn the VS-66H3 off and then turn it on again while pressing the ETH RESET button. The device will power up and load its memory with the factory default IP parameters
2 Covered by a cap. The 3.5mm jack at the end of the internal IR connection cable fits into this opening