Kramer Electronics VS-161H - Manual (Page 19)

16 VS-161H - Operating the VS-161H 16x1 HDMI Switcher
3. Release the PANEL LOCK and INPUT 16 buttons.
If an output was connected, the output EDID is read to all the inputs. If an
output was not connected to the machine, the default EDID is read to the
inputs.
Note: The Mute button flashes if the EDID of the device connected to the output is
different from the EDID which is currently stored.
6.3 Locking and Unlocking the Front Panel
To lock and unlock the front panel buttons:
1. Press and hold the Panel Lock button until the button lights.
The front panel buttons are locked.
2. Press and hold the Panel Lock button again until the button no longer lights.
The front panel buttons are unlocked.
6.4 Resetting the Device to Factory Default Values
To reset to factory default values:
1. Turn the VS-161H off.
2. Press and hold the Reset button on the rear panel while turning the device
on.
3. After approximately five seconds release the Reset button.
The device is reset to its factory default values (see Section 6.4
6.5 Upgrading the Firmware
).
For instructions on upgrading the firmware see “Upgrading the VS-161H Firmware
Using the K-Upload Software”.