1 connecting to the vp-4x8ak via your browser, Connecting to the vp-4x8ak via your browser, 9controlling via the embedded web pages – Kramer Electronics VP-4x8AK User Manual

Page 30

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Controlling via the Embedded Web Pages

Controlling via the Embedded Web Pages

You can remotely operate the VP-4x8AK using a Web browser via the
Ethernet connection (see

Section 9.1

). To be able to do so, you must use a

supported Web browser; Microsoft (V6.0 and higher), Chrome, or Firefox
(V3.0 and higher).

To check that Java is installed correctly and running, browse to:

This page runs a test and displays a Java success (see

) or failure

message.

Figure 15: Java Test Page Success Message

If you do not see the success message, follow the instructions on the page to:

• Load and enable Java
• Enable Javascript in your browser

9.1

Connecting to the VP-4x8AK via your Browser

Make sure that your PC is connected via a network to the VP-4x8AK and do
the following:

1. Open your Internet browser.

2. Enter the unit’s IP number

or name in the Address bar of your browser.

If you are using DHCP, you have to enter the name.

Figure 16: Entering the IP Number in the Address Bar

1 The default IP number is 192.168.1.39, and may be changed by the system integrator