Kramer Electronics RC-IR2 - Manual (Page 20)

The Router Mode Keys
17
Table 7: Groups Definitions for the VP-26
The Switcher Group Is defined as:
VGA/UXGA 1 1
Video (CV) 1 2
s-Video (Y/C) 1 3
Comp 1 4
VGA/UXGA 2 5
Video (CV) 2 6
s-Video (Y/C) 2 7
Comp 2 8
To switch an input to an output, point the remote control transmitter at the
remote receiver and do the following:
1. Press the VIDEO key.
2. Press the group number
1 and then press any key from <1> to <4> 2 to switch an
input to the output .
For example, to switch input 3 in the s-Video group to OUTPUT 2:
Press the VIDEO key
Press 7
Press 3
To switch the master audio switcher, point the remote control transmitter at
the remote receiver and do the following:
1. Press the AUDIO key.
2. Press <1> and then press any key (according to the audio output type key in
Table 8) to switch an input to the Master Audio Output.
7.4.2.2 Adjusting the Volume of the VP-26
You can increase and/or decrease the volume 3 of the VP-26 using the RC-IR2
remote control transmitter.
Increasing the Volume of the VP-26
The volume level on the VP-26 Presentation Switcher can be adjusted
separately for the audio output of each individual switcher, as well as for the
microphone input and the Master audio output.
1 From 1 to according to Table 5
2 Or from 1 to 2 for the component video groups
3 The volume adjustment procedure is slightly different for presentation switchers, for example, the VP-23N or the VP23-RC