Kramer Electronics RC-IR2 User Manual

Page 18

The Router Mode Keys

To switch an input to an output, point the remote control transmitter at the

remote receiver and do the following:
1. Press the VIDEO key.
2. Press the group number

and then press any key from <1> to <4> to switch an

input to the output.

For example, to switch input 3 in the s-Video group to the output:

Press the VIDEO key
Press 2
Press 3

To switch the master audio switcher, point the remote control transmitter at

the remote receiver and do the following:
1. Press the AUDIO key.
2. Press <1> and then press any key from <1> to <4> to switch an input to the

Master Audio Output.

7.4.1.2 Adjusting the Volume of the VP-23N

You can increase and/or decrease the volume

of the

VP-23N using the

RC-IR2 remote control transmitter.

Increasing the Volume of the VP-23N

The volume level on the

VP-23N Presentation Switcher can be adjusted

separately for the audio output of each individual switcher, as well as for the

microphone input and the Master audio output.
To increase the volume, point the remote control transmitter at the remote

receiver and do the following:
1. Press the VOL+ key.
2. Press the numeral key defining the audio signal

continuously until the volume

increase is satisfactory.

1 From 1 to 3 according to Table 5
2 The volume adjustment procedure is slightly different for presentation switchers, for example, the VP-23N or the VP23RC
3 See Table 6. For example, to adjust the microphone audio level, press the <4> key