Festo Контроллер крайних положений SPC11 User Manual

Page 36

Text mode
Original mode

2. Parameters of the SPC11 for the DGP(I)(L)-...

2-4

Festo P.BE-SPC11-DGP-EN en 0012NH

Specifications for setting the parameters

In order to set the parameters, you will require the following
specifications:

–

Cylinder stroke length (see type plate for drive used).

–

Valve type (see type plate for proportional directional
control valve used).

–

Maximum mass load with which the drive is loaded.

Mass load

If you wish to position with different masses:

–

Positioning with a mass up to 30 % less does not usually
present any problems. Further reduction of the mass can
lead to worse positioning behaviour and make optimiz-
ation necessary (see System manual).

–

If necessary, place a basic load on the drive, in order to be
able to set a higher mass. Positioning can then be carried
out with masses of larger sizes.

–

Always set the amplification and cushioning stages for the
maximum mass load used.