Festo Контроллер крайних положений SPC11 - Manual (Page 31)

2. Parameters of the SPC11 for DNCM-..-POT
2-5
Festo P.BE-SPC11-DNCM-EN en 0204NH
2.2 Setting the parameters
Warning
Incorrectly set parameters can damage the fixed stops and
the drive.
Always select the amplification and cushioning stages for
the maximum mass load. In case of doubt, set first the
amplification and cushioning stages for the larger mass
load.
The positioning times specified in section 2.3 as well as opti-
mum system behaviour can only be achieved if the installa-
tion instructions described in the previous section are ob-
served. The resulting positioning times depend on the stroke
length actually used and can vary depending on the direction
of stroke.
Further instructions on the amplification and cushioning
stages can be found in the system manual.
Set the parameters as follows:
1. Use the tables in section 2.3 and in section 2.4 to ascer-
tain the parameters valid for your application (amplifica-
tion stage, cushioning stage and system parameters).
2. Then set the parameters accordingly. Proceed here as
described in the chapter “Commissioning” in the system
manual (type P.BE-SPC11-SYS...).
The following diagram explains the tables: