EZ Dupe 5 Copy 3.5" SATA Hard drive Duplicator copies up to 60MB/s. Adapter is needed for 2.5 SATA HDD" - Manual (Page 8)

SATA HDD Duplicate Controller Manual
3.3 Compare
Compare HDD is used to see if the data on a source hard disk is identical to the target hard disk
after the Copy HD operation.
Choose option 3 from the menu:
3. Compare HDD
HDD: 11
232.9GB
Press ENT to begin the comparison. The LCD will display the following info.
Comp-23MB/s 0%
232.9GB 00:00:00
Once the comparison is complete the LCD will display the following info as well as the amount of
data on the source hard disk.
Compare OK:11
Fail: 0
Diff: 0
Attention: This is Function 2 of 1-1 HDD duplicator.
3.4 Async Compare
This option allows extra hard disk devices to be added during compare process.
Choose option 4 from the menu:
4. Async Compare
HDD: 10
232.9GB
Press ENT to begin the async comparison. The LCD will display the following info.
ACmp-23MB/s 0%
232.9GB 00:00:00
If the comparison process to continue to add additional hard disk device, LCD will only show the
last completed percentage.
Once the compare process is complete the LCD will display the following results.
Compare OK:11
Fail: 0
Diff: 0
3.5 PreScan HD
PreScan HD is used to check if the source hard disk can be accessed properly. It also tests the
read speed.
Choose option 5 from the menu:
5. PreScan Source
HDD : 11 232.9GB
Press ENT to begin scan. The LCD will display the following info
Scan-90MB/s 1%
230.6GB 00:00:27
7