EZ Dupe 5 Copy 3.5" SATA Hard drive Duplicator copies up to 60MB/s. Adapter is needed for 2.5 SATA HDD" - Manual (Page 14)

SATA HDD Duplicate Controller Manual
3.10 Adv Setup
Adv Setup offers expert users access to more advanced system settings. It has 9 sub-options:
Read Error Skip, Upadate Firmare, Compare Firmware, Quick Erase HDD, Full Erase HDD, H/W
Diagnostic, Load Default, Copy HPA and Burn In.To access this option, hold down the
ESC key for
two seconds until it appears.
9. Adv Setup
3.10.1 Read Error Skip
This function sets the system to ignore any errors during the copying process. Normally if there is
an error during copying a warning is displayed on the LCD. By using this function, users can also
copy a HDD with errors.
9-01. Adv Setup
Read Error Skip
Press ENT to enter the following screen. By default this option is set to OFF. Use the up and down
buttons to enable or disable this option.
Read Error Skip
Off
3.10.2 Update Firmware
This function is used to update the system's firmware. Please get the firmware from the distributor
or reseller of HDD duplicator and then write it on to a blank CD.
9-02. Adv Setup
Update Firmware
Shut down the HDD cloner. Restart the system and insert the CD with the latest version of the
firmware into the DVD-ROM.
Press ENT and the system will begin scanning for a new firmware version. If found, this will be
displayed on the LCD as shown below.
Press ENT again to begin updating. If the upgrade is successful the system will restart
automatically.
Searching F/W ...
Please Wait ... Upate F/W X.XX
To X.XX -> Yes
13