EZ Dupe 5 Copy 3.5" SATA Hard drive Duplicator copies up to 60MB/s. Adapter is needed for 2.5 SATA HDD" - Manual (Page 17)

SATA HDD Duplicate Controller Manual
3.10.8 Copy HPA
If this function is set to "ON", the system will completely copy the data in a source HDD's host
protected area.
9-08. Adv Setup
Copy HPA
The default is "OFF". Use the ENT, Up and Down buttons to change this to "On".
USB Auto-Link
OFF
Attention: This is Function 9.10 of 1-1 HDD duplicator.
3.10.9 Burn In
This function is used to burn test the system reliability.
9-09. Adv Setup
Burn In
Press ENT to enter the following screen.
Burn In Mode
Copy & Compare
Use the Up and Down buttons to choose Compare, Async Copy & Cmp and Async Compare, then
press
ENT to confirm.
Attention: 1-1 HDD duplicator does not have this function.
3.10.10 Detect HDD Delay (1-1 HDD duplicator only)
This function is used to set the time interval between the system's re-scans of all connected HDD
devices.
Press
ENT and the LCD will show the following info.
9-01. Adv Setup
Detect HDD Delay
Press ENT then use the Up and Down buttons to choose different time settings (1~60 sec)
Detect HDD Delay
1Sec
Attention: This is Function 9.1 of 1-1 HDD duplicator.
16