EZ Dupe 5 Copy 3.5" SATA Hard drive Duplicator copies up to 60MB/s. Adapter is needed for 2.5 SATA HDD" - Manual (Page 13)

SATA HDD Duplicate Controller Manual
3.8.13 Quick Compare
This option is used to set the size of each comparison unit.
8-13. Setup
Quick Compare
Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to
choose 1 Byte/1K/10K/100K/1MB/10MB/100 Mbytes. (In order to improve the accuracy of pure
data can maintain the default settings.)
Quick Compare
Off
3.8.14 Copy with Size (for 1-11 HDD Duplicator only)
This option is used to set the source hard disk with the target hard disk the same capacity after a
copy operation.
8-05. Setup
Copy with Size
Press ENT to enter the following figure. The default is Off. Use the Up and Down arrow keys to
choose On.
Copy with Size
Off
Attention: This is Function for 1-11 HDD duplicator only.
3.9 USB Mode (for 1-1 HDD Duplicator only)
This option allows a copy controller connected to the host computer's USB port to be operated
from the PC.
Choose option 7 from the menu:
7. USB Mode
Press ENT and the LCD will display the corresponding information as shown below.
Switch USB Mode?
NO
Use the Down arrow to select YES then press ENT again to switch to USB Mode. The LCD will
display the following info.
USB L.H Mode
D1:HDD D2:HDD
Now press ENT to switch to stand-alone mode. The LCD will display the following info.
Copy Mode
Attention: This is Function for 1-1 HDD duplicator only.
12