ConTech Lighting TMCFP - Manual (Page 2)

TMCFP Pendant Height Adjustment
1. Unscrew the strain relief plate at the bottom of the ballast housing.
2. Disconnect the ballast from the pendant wiring.
3. Loosen the Allen screw on the strain relief near the ballast housing.
4. Loosen the Allen screw on the strain relief near the socket and unscrew the
strain relief from the threaded nipple.
5. Pull the bicycle cable off of the pendant.
6. Cut the bicycle cable to the desired length making sure to remove any sharp
edges on the inside of the bicycle cable with a small round file.
7. Insert the pendant black and white wires back into the bicycle cable, and slide
the bicycle cable through the strain relief and into the threaded nipple near the
socket.
8. Screw the strain relief to the threaded nipple for a snug fit between the strain
relief, washers and glass.
9. Tighten the Allen screw in the strain relief.
10. Cut the white and black pendant wires, allowing enough length to insert into the
ballast housing and to wire to the ballast.
11. Insert the bicycle cable through the strain relief plate and rewire the ballast
using the wiring diagram below.
12. Tighten the strain relief plate with the included Allen wrench
13. Screw the strain relief plate back onto the ballast housing.
14. Track polarity is indicated by a grooved polarity line that runs the entire length of
the track.
15. Install the pendant into the track so the arrow on the fixture tab points to the
polarity line when it is rotated into place.
16. Insert the correct lamp per product identification label.
www.con-techlighting.com 1-800-728-0312 CMCFP INST
All specifications subject to change without notice.
ASSEMBLY AND HEIGHT ADJUSTMENT INSTRUCTIONS
For the Con-Tech Lighting Track Mount Compact Fluorescent Pendants (TMCFP series)
13W/18W/26W
Strain Relief
Metal Washers
Adjustment Nut
Socket
Glass seats between the two sets of washers
Silicone
Washers