ConTech Lighting RL420T6MHE - Manual

Phone:�800.728.0312�����Fax:�847.559.5505�����www.con-techlighting.com
INSTALLATION INSTRUCTIONS
For�Con-Tech Non-IC�4"�&�6"�Metal�Halide�Recessed�Housings
Models:�RL4__T4MHE,�RL4__T6MHE,�RL6__T4MHE,�RL6__T6MHE�
Installation Procedures:
FOLLOW NEC AND LOCAL ELECTRICAL CODES WHEN INSTALLING
PRODUCTS. CONSULT QUALIFIED ELECTRICIAN TO ENSURE PROPER
INSTALLATION.
CAUTION – RISK OF FIRE
Insulation must not be used in direct contact with fixture. Provide 3" space
between any part of fixture and insulation.
MOUNTING:
1. Remove bag containing ìWing Type Mounting Bracketsî from carton.
2. Install brackets by fitting the key hold slots over the (4) setscrews on
mounting plate. Adjust to desired length and tighten screws.
3. Mount the wing-style to the vertical slot with the open end facing out (See
Fig. 2)
4. The style mounting bracket will accept flat hanger bars (Con-Tech Part
Number HB-24), C-channel hanger bars (Con-Tech Part Number
HBC-24), or the electrician can use 1/2" conduit.
5. Plaster frame edge should be even with the finished ceiling and wing nuts
can be firmly tightened to secure mounting bracket. (See Fig. 3)
6. Loosen housing set screws.
7. Adjust housing flush to finish ceiling and tighten screws.
ELECTRICAL CONNECTIONS:
WARNING - Power source must conform to the requirements of the fixture
(see labels on fixture), all NEC and local electrical codes. Before starting the
wire connections, disconnect power at circuit breaker or fuse, turning power
off at switch leg is not sufficient to prevent electrical shock.
1. Supply wire must be rated at 90°C or higher.
2. Connect power source to fixture junction box.
3. Connect blacks to blacks (hot), whites to whites (neutral), and greens to
greens (ground) with twist type wire connectors (not provided). (See Fig. 4)
4. Close junction box cover after wiring (ensure that all wires are within box
before closing).
LAMPING/TRIMS:
1. Place lamp pins into the 2 holes in ceramic lamp socket. Push into place
to make connection.
2. Connect socket cup to top of housing.
3. Remove trim from box and assemble per trim instructions. Push 2-piece
reflector up into housing until trim is seated firmly against ceiling.
4. Twist trim 1/4 of a turn to secure.
Housing
Wing Type
Mounting
Brackets
Wing Type Mounting Brackets
Flexible
Conduit
Mounting
Plate
Mounting
Plate