ConTech Lighting CA16 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
For Incandescent Stemlight Pendant Series:
CM12, CA12 and CA16
www.con-techlighting.com 1-847-559-5500 INCNSTMLT INST All specifications subject to change without notice.
2
WIRING INSTRUCTIONS
Attach the bicycle cable connector to the nipple of the track adapter plate. Red
Socket Lead to the center of the socket or bottom solder contact. Blue socket lead
to the brass threading of the lamp. Attach bicycle cable connector to the bicycle
cable, attach bicycle cable connector to the nipple on the canopy. Tighten all of the
2mm Allen Screws along the way to the maximum. Insert socket wiring through the
nipple. Wiring is (Blue-to-White, Red-to-Black, Green-to-Green). Insert the wiring into
the nipple. Using the (2) Pan Head Screws, attach the fixture assembly/bottom plate
to the track adapter or ceiling canopy.
SHADE ASSEMBLY INSTRUCTIONS
Metal Shade: Open the bottom lens assembly by loosening the (3) thumb screws.
Insert the proper wattage lamp into the E26 Medium Base Socket.
Close the bottom lens assembly and tighten the (3) thumb screws.
Acrylic Shade: Remove the reflector assembly from the shade/hood/socket assem-
bly by removing the (3) brass screws attached to the metal housing
plate. Place the acrylic shade onto the housing so it sits on the
metal housing plate. From the inside of the acrylic shade, place the
white shade retaining plate onto the metal housing plate. Align the
(3) three holes in the white shade retaining plate with the metal
housing plate, and tighten the plates together with the (3) three
screws. When tightened, this will secure the acrylic shade to the
fixture housing. Insert the proper wattage lamp into the E26 Medium
Base socket. The socket is adjustable vertically, however, the lamp
position from the factory is in the proper wide distribution setting.
Top of Canopy