Chemglass 75L thru 100L Jacketed - Manual (Page 3)

www.cglifesciences.com [email protected]
Overhead Stirrer Motor
Air Motor 1/4 HP Vertical Motor
1/4 HP Horizontal Motor Explosion Proof (XP) Motor
The motor is installed on the support frame when shipped. Use the following instructions should you need to remove or
adjust these components.
Components Needed for Overhead Stirrer Motor:
1ea
CG-2033-11 1/4 HP Vertical Electric Stirrer Motor
1ea CG-2033-13 1/4 HP Horizontal Electric Stirrer Motor
1ea CG-2025-20 Air Motor* (Optional)
1ea CG-2033-31 Digital Electric Stirrer Motor Controller (Only Supplied with 1/4 HP Electric Stirrer Motor)
1ea CG-2046-95 Universal Stirrer Shaft Coupling
1ea CG-9253-20 Large Kwik Klamp II
1ea CG-3498-03 90° Support Rod
1. The support frame has a universal motor mount. It can be used with an (vertical or horizontal) electric, air, or
optional explosion proof (XP) motor. The mount automatically centers the motor directly above the reactor.
PLEASE NOTE: IT MAY BE EASIER TO FIRST ATTACH THE MOTOR TO THE UPPER UNIVERSAL
MOTOR MOUNT ARM, AND THEN PLACING ABOVE THE REACTOR.
2. Attach the 1/4 HP electric motor to the universal motor mount arm via four socket head cap screws. Screws are
shipped installed on the motor.
3. Lower the motor mount (with motor securely attached) in to place and tighten all Allen screws.
4. Attach the universal stirrer shaft coupling to the motor shaft.
5. When using the 1/4 HP electric motor, the digital controller with the mounting bracket on the back panel, needs to
be mounted on a S.S. upright. Use the large Kwik Klamp II and 90°support rod to mount the controller to the
support frame. Tighten all knobs securely.
*The Air Motor requires the air supply be filtered and a lubricator be installed between the air source and motor. Filter-Regulator-
Lubricator (CG-2025-10) is available separately.