Chemglass CG-1969-M - Manual

Inlet Manifold Outlet Manifold
SETUP INSTRUCTIONS
High Flow Manifold System For
Process Reactors 10L Thru 50L
CG-1969-M-01 thru M-07
3800 North Mill Road • Vineland, NJ 08360
Phone: 800.843.1794 • Fax: 800.922.4361
[email protected] • www.chemglass.com
General Specifications:

Temperature limitations on manifolds are -60 to 200°C.

Cracking Pressure On Relief Valve is 10 ± 1 PSI (12 Gallon/min)

GREEN Inlet Hose is restricted to 5/8in. diameter
Triple Insulated Flexible Hose
Alternative Setup: Combination
Inlet Manifold with :
1. Attach the supplied 3ft Triple Insulated Flexible Hose to back port of manifold block
and attach plug to front port of manifold block. All NPT threads must be sealed with
supplied thread sealant.
2. Mount Inlet Manifold to left or right S.S. upright.
3. Attach the hose to the reactor inlet using a Beaded Pipe Coupling (sold separately).
Tighten coupling to proper torque setting.
4. Attach circulator hose (sold separately) to bottom of inlet manifold block via the M16
or M30 thread. Hand tighten plus 1/4 turn with wrench.
Outlet Manifold with 2” Pressure Gauge & Pressure Relief Valve:
1. Attach the supplied 4ft long Triple Insulated Flexible Hose to back port of manifold
block and attach plug to front port of manifold block. All NPT threads must be sealed
with supplied thread sealant.
2. Mount Outlet Manifold to left or right S.S. upright.
3. Pressure valve may need to be positioned so that the 3/8” OD overflow hose barb is
pointing back. This may require breaking the seal on the thread.
4. 15 PSI pressure gauge can be easily rotated to face forward by loosening the swivel
locking nut. Be sure to re-tighten with a wrench.
5. Attach the hose to the reactor outlet using a Beaded Pipe Coupling (sold separately).
Tighten coupling to proper torque setting.
6. Attach circulator hose (sold separately) to bottom of outlet manifold block via the M16
or M30 thread. Hand tighten plus 1/4 turn with wrench.
Rev C 080707
Outlet
Close-up
Inlet
Close-up