Installing your t-glide fence system – SawStop T-Glide Fence System User Manual

Page 7

SawStop, the

SawStop blade

logo, and

the

configuration

of this product

are either reg

istered

trademarks

or trademarks

of SawStop,

LLC.

Software copyright

2003-2006 by

SawStop, LLC

. Protected

by one or more

the following

U.S. patents

6813983, 68269

88,

6857345, 6877410,

6880440, 692

0814, 69451

48,

6945149, 6957601,

6994004, 69

97090, 7000

514,

7024975, 70554

17, 7077039,

7098800, 7100483,

7137326, 717187

9, 7197969,

7210383, 72

25712,

7228772, 7231856

and Taiwan

patent 14346

Additional U.S.

and foreign patents pending.

WARNING

Do not remo

ve the dust

shroud because

the blade will

be exposed.

If you contact

the

blade under the

table, the blade

may retract

toward you

and cause

a severe injury

Installing Your T-Glide Fence System

Fig. 8

8. Use a straight-edge to level the rear edge of the

left extension wing to the cast iron table top (see

Fig. 8). You may have to pull up or push down on

the outer edge of the extension wing to level it.

Once the rear edge of the left extension wing is

level, use a 5 mm hex key and a 13 mm wrench

to fully tighten the nut on the bolt that mounts

the left extension wing to the rear rail. Repeat

this process to level the rear edge of the right

extension wing.

9. Once the rails are in place you can mount the extension

table to the rails, but first you must mount the support

leg or legs to the extension table. The extension

table for the 36” fence system has one support leg

and the extension table for the 52” fence system has

two. Locate the support legs, the angle brackets, and

the T-Glide table hardware pack. Begin by installing

the adjustable foot in the bottom of each support leg.

Thread an M8 nut onto the threaded shaft of the foot

as close to the rubber base as possible, and then

thread the foot into the bottom of the support leg as

far as possible (see Fig. 9).

Fig. 9

Fig. 10

10. Each support leg is mounted to the underside of the extension table using two angle brackets. Align the two

holes in the support leg to the two holes in the brackets as shown in Fig. 10. Put one of the M10 x 45 hex head

bolts through each hole in the leg and brackets.

Thread an M10 nylon lock nut on each bolt and

tighten with a 17 mm wrench. You will need to

hold the head of the hex bolt with another 17

mm wrench to tighten the lock nut. Do not fully

tighten the nuts; leave them just loose enough to

be able to move the brackets.

level the extension

wing and tighten the

nut on this bolt

angle bracket

support

leg

straight-edge

Countersunk Socket

Head Bolts, M8 x 25 (6)

Washers,

M8.5 x 23 (6) 19

Lock Washers,

M8 (6)

Philips Head Screws,

M4 x 16 (12)

Foot,

(2)

Hex Head Bolts,

M10 x 45 (4) 15

Hex Nuts,

M8 (8) 14

Nylon Lock Nuts,

M10 (4)

T-Glide 52” Table Hardware Pack

SawStop T-Glide Fence System - Professional Series 5